Circuit Description
This diagnostic DTC is used to monitor the field voltage of the generator. The generator is able to produce the desired voltage by varying the duty cycle of the field current. At low engine speeds, the field may have a duty cycle of 90%. At higher engine speeds and lower electrical loads, the duty cycle will be less. The generator produces a PWM signal that is monitored by the PCM on CKT 23 at connector C1 terminal 54. This signal duty cycle is sent to the PCM and if it falls below a certain duty cycle for too long, DTC P1638 will set.
Conditions for Running the DTC
| • | Engine has been running for at least 60 seconds |
| • | Engine speed between 500 and 3000 RPM. |
Conditions for Setting the DTC
Generator F-terminal duty cycle is 5% or less for 20 seconds.
Action Taken When the DTC Sets
| • | The Malfunction Indicator Lamp (MIL) will not illuminate. |
| • | The PCM will command a message to be displayed. |
| • | The PCM may record operating conditions at the time the diagnostic fails. This information will be stored in the Failure Records. |
Conditions for Clearing the Message/DTC
| • | The PCM will turn the message OFF after one run and pass of the diagnostic test. |
| • | A History DTC will clear after forty consecutive warm-up cycles with no failures of any non-emission related diagnostic test. |
| • | A Last Test Failed (current) DTC will clear when the diagnostic runs and does not fail. |
| • | Use a scan tool to clear DTCs. |
Test Description
Number(s) below refer to the step number(s) on the Diagnostic Table.
-
If DTC P0560 is also set, diagnose it first because the charging system may be faulty.
-
If the DTC is history, an intermittent wire problem may be present.
-
If the duty cycle is greater than 0%, the generator may be faulty.
-
If the duty cycle is greater than the failure threshold, the PCM may be faulty.
Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
1 | Did you perform the Powertrain On-Board Diagnostic (OBD) System Check? | -- | ||
Connect the diagnostic tool, key ON. Is DTC P0560 also set? | -- | Go to DTC P0560 System Voltage | ||
Has this DTC failed this ignition? | -- | Fault not present. Go to Diagnostic Aids. | ||
Is the duty cycle greater than the value specified? | 0% | |||
Is the duty cycle less than 5%? | -- | Go to Generator Not Operating Properly in Engine Electrical. | ||
6 |
Is the voltage more than the value specified? | 0.1 volts | ||
7 | Measure resistance to ground at PCM connector C1 terminal 54 (harness side). Is resistance less than the value specified? | OL | ||
8 | Measure the resistance between PCM connector C1 terminal 54 and generator connector C1 terminal C. Is the resistance the same or less than the value specified? | 5 ohms | Go to Generator Not Operating Properly in Engine Electrical. | |
9 | Repair short to voltage on the F terminal circuit. Is the repair complete? | -- | -- | |
10 | Repair short to ground on the F terminal circuit. Is the repair complete? | -- | -- | |
11 | Repair open in the F terminal circuit. Is the repair complete? | -- | -- | |
12 |
Was terminal contact repaired? | -- | ||
13 |
Was terminal contact repaired? | -- | ||
14 | Replace the PCM. Refer to Powertrain Control Module Replacement/Programming . Is the replacement complete? | -- | -- |
