Notice: Do Not attempt to repair the EVAP pipes or the connecting hoses. Replace the damaged EVAP pipes or the connecting hoses are damaged. If the nylon EVAP pipe becomes kinked and cannot be straightened, it must be replaced.

1. Raise the vehicle.
2. Remove the hardware retaining the EVAP pipe or disconnect the quick connect fittings (3).
3. Note the location of the attaching hardware for installation.
4. Remove the EVAP pipe.
5. Inspect the hoses for cuts, swelling, cracks, and distortion. Replace the hoses as required.
6. Inspect the pipes for bends, kinks, and cracks. Replace the pipes as required.

Notice: Properly secure the EVAP pipe in order to prevent chafing of the pipe.

Important: Route the replacement EVAP pipe in the same manner as the original EVAP pipe was routed.




1. Install the EVAP pipe (3).
2. Install the quick connect or hardware retaining the EVAP pipe.
3. Lower the vehicle.