- Remove the key from the
ignition switch.
- Connect the inflatable restraint IP module yellow 2-way connector (1).
- Attach the inflatable restraint IP module yellow 2-way connector (1)
to the IP sheetmetal.
- Verify that the pigtail and harness wiring is routed away from
the HVAC mix door actuator.
- Install the IP compartment.
- Install the Connector
Position Assurance (CPA) (2) to the inflatable restraint IP module yellow
2-way connector (1).
- Connect the inflatable
restraint steering wheel yellow 2-way connector (4) located near the base
of the steering column (2).
- Install the Connector
Position Assurance (CPA) (4) to the inflatable restraint steering wheel yellow
2-way connector (1) located near the base of the steering column (2).
- Install the sound insulator-LH.
- Procedure for Enabling
the side air bags (1).
10.1. | Connect the inflatable restraint side air bag inflator module
yellow 2-way connector (2). |
10.2. | Install the Connector Position Assurance (CPA) (3) to the inflatable
restraint side air bag module yellow 2-way connector (2). |
- Install the SIR Fuse to the trunk compartment fuse block.
- Staying well away from both air bags, turn the ignition switch
to the RUN position.
12.1. | The AIR BAG warning lamp will flash seven times. |
12.2. | The AIR BAG warning lamp will then turn OFF. |
- Perform the SIR Diagnostic System Check if the AIR BAG warning
lamp does not operate as described.