Warning: Refer to Exhaust Service Warning in the Preface section.

Warning: Refer to Protective Goggles and Glove Warning in the Preface section.

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Support the exhaust system near the resonator with a suitable jack.
3. Remove the oxygen sensor. It is not necessary to disconnect the electrical connector.



4. Remove the nuts securing the catalytic converter to the exhaust manifold pipe.



5. Remove the bolts securing the center exhaust hangers to the rear suspension support brackets.
6. Remove the catalytic converter from the manifold pipe.
7. Lower the exhaust system.



8. Remove the catalytic converter gasket (1). Do not reuse the gasket.




Note: Ensure the cut (1) is made 34 mm (1.3 in) from the weld on the intermediate pipe.

9. Cut the intermediate pipe 34 mm (1.3 in) from the resonator weld.

1. Slide 2 service clamps (1) over the catalytic converter assembly outlet pipe.

Do not tighten at this time.





Note: Ensure the O2 sensor boss is facing the right side of the vehicle.

2. Slide the catalytic converter assembly (1) outlet pipe over the intermediate pipe (2).

Caution: Refer to Exhaust System Inspection Caution in the Preface section.




3. Place a NEW catalytic converter gasket over the catalytic converter studs.

Caution: Refer to Flex Decoupler Caution in the Preface section.

4. Raise the exhaust system into position, aligning the catalytic converter with the exhaust manifold pipe.
5. Install the nuts securing the catalytic converter to the exhaust manifold pipe.

Do not tighten at this time.

Caution: Refer to Fastener Caution in the Preface section.




6. Install the bolts securing the center exhaust hangers to the rear suspension support brackets.

Tighten
Tighten the center exhaust hanger bolts to 30 N·m (22 lb ft).

7. Tighten the catalytic converter nuts.

Tighten
Tighten the catalytic converter nuts in a crisscross pattern to 25 N·m (18 lb ft).

8. Remove the jack from under the vehicle.



9. Position the service clamps midway on the catalytic converter assembly outlet pipe, as close together as possible.
10. Rotate the clamps so the fastening ends are pointing in opposite directions.

Tighten
Tighten the service clamps to 54 N·m (40 lb ft).

11. Lower the vehicle.
12. Check the exhaust system for leaks.