Removal Procedure
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
- Remove the left exhaust muffler to resonator clamp nut (2).
- Remove the muffler pipe flange bolts (1).
- Remove the exhaust hanger insulator retainers.
- Remove the exhaust hanger insulators from the support rods and the muffler.
- Rotate and remove the left muffler from the resonator.
Installation Procedure
- Install the left muffler to the resonator.
- Install the exhaust hanger insulators to the support rods and the muffler.
- Install the exhaust hanger insulator retainers to the support rods.
- Install the muffler pipe flange bolts (1).
- Install the left exhaust muffler to resonator clamp nut (2).
- Inspect all exhaust system clearances.
- Lower the vehicle.
- Inspect the exhaust system for leaks.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the muffler pipe flange bolts (1) to 40 N·m
(30 lb ft).
Tighten
Tighten the left exhaust muffler to resonator clamp nut (2) to
25 N·m (18 lb ft).
