Removal Procedure
- Remove the sunroof switch selector knob by pulling knob in a downward motion.
- Remove the potentiometer from the sunroof switch by releasing tabs (push inward).
- Remove the dome lamp lens with a small flat-bladed tool.
- Remove the electrical connectors from the dome lamp.
- Remove the screws from the actuator motor cover.
- Remove the sunroof actuator motor cover, pull down and forward to release actuator motor cover from headliner.
Remove the dome lamp from the actuator cover with a small flat-bladed tool.
Installation Procedure
- Install the sunroof actuator motor cover to the headliner.
- Install the screws to the sunroof actuator motor cover.
- Install the electrical connectors to the dome lamp.
- Install the dome lamp into the actuator cover and press until fully seated.
- Install the potentiometer to the sunroof switch.
- Align selector knob with shaft for sunroof switch and press knob untill fully seated.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten screws to 2 N·m (18 lb in).
Install dome lamp lense to the dome lamp and press until fully seated.
