Tools Required

1. Remove the inflatable restraint steering wheel module. Refer to Inflatable Restraint Steering Wheel Module Replacement in SIR.
2. Reposition the locking tab on the steering wheel nut.



3. Remove the steering wheel nut.
4. Remove the steering wheel nut locking tab.
5. Matchmark the steering wheel to the steering column.




Notice: When removing the steering wheel, use only the specified steering wheel puller. Do not hammer on the end of the steering column shaft. Hammering could loosen the plastic injections which maintain the steering column rigidity.

6. Pull off the steering wheel using J 1859-A and J-36541-A .

1. Install the steering wheel to the column using the matchmarks.



2. Install the steering wheel nut locking tab.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the steering wheel nut.

Tighten
Tighten the nut to 28 N·m (21 lb ft).

4. Secure the nut with the locking tab.
5. Install the inflatable restraint steering wheel module. Refer to Inflatable Restraint Steering Wheel Module Replacement in SIR.