Tools Required

J 39400-A Halogen Leak Detector

1. Recover the refrigerant from the A/C system. Refer to Refrigerant Recovery and Recharging .



2. Remove the evaporator tube extension block fitting bolt.



3. Remove the LF floor air outlet duct.



4. Remove the vacuum solenoid screws.
5. Disconnect the solenoid connectors.
6. Position the solenoids out of the way.



7. Remove the evaporator access panel screws.
8. Remove the evaporator access panel.



9. Remove the evaporator tube screw.
10. Remove the evaporator tube.

1. Install the evaporator tube:

•	Use new O-rings.

•	Lubricate the new O-rings with mineral oil, 525 viscosity.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the evaporator tube screw.

Tighten
Tighten the screw to 5 N·m (44 lb in).




3. Install the evaporator access panel.
4. Install the evaporator access panel screws.

Tighten
Tighten the screws to 1.5 N·m (13 lb in).




5. Position the vacuum solenoids.
6. Install the vacuum solenoid screws.

Tighten
Tighten the screws to 1.5 N·m (13 lb in).

7. Connect the actuator connectors.



8. Install the LF floor air outlet.



9. Install the evaporator tube extension block fitting bolt.

Tighten
Tighten the bolt to 20 N·m (15 lb ft).

10. Evacuate and recharge the A/C system. Refer to Refrigerant Recovery and Recharging .
11. Leak test the fittings of the component using J 39400-A .