Removal Procedure
- Partially drain the cooling system. Refer to
Cooling System Draining and Filling
.
- Remove the surge tank
hoses from the surge tank.
- Remove the heater hoses from the surge tank.
- Remove the surge tank clip (1).
- Slide the surge tank (2) inward until the tabs disengage
to remove from the wheelhouse panel.
- Disconnect the low coolant level switch connector (3) and
remove the surge tank.
- Clean the surge tank using a mild soap and water if the surge
tank is to be reused.
Installation Procedure
- Connect the low coolant
level switch connector (3).
- Install the surge tank (2) to the wheelhouse
panel.
- Install the surge tank clip (1).
- Install the heater hoses to the surge tank.
- Install the surge tank hoses.
- Fill the cooling system. Refer to
Cooling System Draining and Filling
.