The sunroof features a glass panel with a manually operated
sunshade. It is electrically operated from a potentiometer switch, that is
located in the overhead console (center).
To open the sunroof, turn the ignition switch to the RUN position, then
turn the sunroof rotary type switch to the rearward position. The glass panel
will retract and slide rearward into the storage space between the roof
panel and the headliner. As the glass retracts, the wind deflector extends
above the roof line.
To close sunroof, turn the potentiometer switch in the forward position
until the glass completely closes, retracting the wind deflector and sealing
against the roof opening flange. If the operator turns the rotary type
switch past the forward position, after the glass has completely closed.
The rear of the glass panel will rise to the vent position. To close the
glass, turn the rotary switch to the forward position again and the glass
will lower and reseal to the roof opening. The sunroof potentiometer switch
allows the sunroof be set to many positions. The potentiometer module is
non serviceable, and is made in conjunction with the motor. The scan tool
is also available to diagnose and check the function of the sunroof potentiometer
module.
The sunroof is equipped with a pinch guard for safety.
| • | Pinch guard is in a effect
when the glass panel is open: |
| - | The pinch guard is effective in an opening width of 4-200 mm
(0.15 in to 8 in). |
| - | If an obstruction is met, the glass panel returns to an opening
width of 220 mm (8.5 in). |
| • | Pinch guard with tilted
glass panel: |
| - | The pinch guard is effective when the glass panel is tilted 4-40 mm
(0.15 in to 1.5 in). |
| - | If an obstruction is met, the glass panel returns to the glass
panel fully tilted position. |
| - | The pinch guard can be overruled with the ignition switched to
RUN position, to bring the glass panel into the closed position, by placing
the (rotary knob) in the closed position and pressing knob. |
When the battery is disconnected, power is lost to the programmer or
if the motor is removed the sunroof must be reprogrammed. Refer to
Power Sunroof Operation
.
