Caution: Refer to SIR Handling Caution in the Preface section.

1. Remove the radio/tape player. Refer to Radio Replacement in Entertainment.



2. Remove the Heating and A/C control (H-A/C) screws.
3. Disconnect the H-A/C control electrical connections.



4. Remove the H-A/C control.

Continue with the following procedures if:

•	If servicing the H-A/C control indicator bulbs.

•	If servicing the H-A/C control bracket.

•	If servicing the Printed Circuit Board (PCB).




5. Perform the following steps to remove the H-A/C control from the bracket:

5.1.	Depress the tabs (1) on the side of the control face to release the H-A/C from the bracket.

5.2.	Slide the H-A/C out of the bracket.




6. Use a flat-bladed tool to turn the H-A/C control indicator bulbs counterclockwise to remove the H-A/C control indicator bulbs from the H-A/C control.
7. Remove the PCB from the H-A/C control.
8. Remove the ribbon from the H-A/C control.

1. If applicable, install the PCB to the H-A/C control.
2. Install the ribbon to the H-A/C control.



3. Use a flat-bladed tool to turn the H-A/C control indicator bulbs clockwise to install the H-A/C control indicator bulbs to the H-A/C control.



4. Perform the following steps to install the H-A/C control to the bracket:

4.1.	Slide the PCB into the slot.

4.2.	Snap the H-A/C control face into the bracket.




5. Install the H-A/C control.
6. Connect the H-A/C control electrical connectors.



7. Install the H-A/C control screws.

Tighten
Tighten the H-A/C control screws until fully seated and not stripped the H-A/C control screws.

8. Install the radio/tape player. Refer to Radio Replacement in Entertainment.
9. Program the H-A/C control with a scan tool by selecting the programming procedure from the Air Conditioning Special Functions menu and follow the instructions on the screen.