Tools Required

1. Remove the drive flange. Refer to Drive Flange and Seal Replacement .
2. Remove the catalytic converter support bracket bolts (1) and bracket.
3. Remove the transmission mount. Refer to Transmission Mount .



4. Disconnect the speed sensor electrical connector.
5. Remove the speed sensor retainer bolt.
6. Remove the speed sensor with the seal. Use hand pressure to rotate the sensor back and forth while pulling outward. Do not pry on the sensor.



7. Remove rear oxygen sensor harness clips (112) from the case extension.
8. Remove the transmission case extension bolts (52).
9. Remove the transmission case extension (43).
10. Remove the transmission case extension gasket (42).

1. Install the new transmission case extension gasket (42).
2. Install the transmission case extension (43).

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the transmission case extension bolts (52).

Tighten
Tighten the transmission case extension bolts to 32 N·m (23 lb ft).

4. Install the rear oxygen sensor harness clips (112) to the case extension.



5. Install the speed sensor seal (44) and sensor (45).
6. Install the speed sensor retainer bolt (46).

Tighten
Tighten the speed sensor retainer bolt to 9 N·m (78 lb in).

7. Connect the transmission speed sensor electrical connector.



8. Install the catalytic converter support bracket.
9. Install the catalytic converter support bracket bolts (1).



10. Install the drive flange. Refer to Drive Flange and Seal Replacement .
11. Install the transmission mount. Refer to Transmission Mount .
12. Inspect and adjust the transmission fluid level. Refer to Transmission Fluid Check .