Removal Procedure
The passenger side air mix actuator is located on the lower, RH side
of the HVAC module. The actuator is below and forward of the heater core.
- Remove the RF floor air outlet.
- Remove the passenger side
air mix actuator cover screws.
- Remove the passenger side air mix actuator cover (1).
- Disconnect the passenger side air mix actuator electrical connector
(3).
- Remove the passenger side air mix actuator screws (2).
- Remove the linkage (from the passenger side air mix actuator.
- Remove the passenger side air mix actuator.
Installation Procedure
- Install the passenger
side air mix actuator.
- Install the linkage (2) to the passenger side air mix actuator.
- Install the passenger side air mix actuator screws until fully
seated and not stripped.
- Connect the passenger side air mix actuator electrical connector
(3).
- Install the passenger side air mix actuator cover (1).
- Install the passenger side air mix actuator cover screws until
fully seated and not stripped.
- Install the RF floor air outlet.
- Synchronize the actuators:
• | Turn the ignition switch to the ON position. |
• | Simultaneously press and hold the AUTO and OFF buttons on the
H-A/C control panel for at least 5 seconds. |