Step
| Action
| Value(s)
| Yes
| No
|
DEFINITION:
LH or RH turn signal indicator is inoperative.
|
1
| Did you perform
the Exterior Lights Diagnostic System Check?
| --
| Go to
Step 2
| Go to
Exterior Lights System Check
|
2
|
- Turn the ignition switch to the ON position.
- Determine if the LH or RH turn indicator is inoperative.
Is the LH turn indicator inoperative?
| --
| Go to
Step 7
| Go to
Step
3
|
3
|
- Disconnect the instrument cluster connector.
- Engage the turn signal switch so that the RH turn indicator is
supposed to be on.
- Use a DMM in order to measure the voltage between terminal 18
of instrument cluster connector and a known good ground.
- When the turn signal switch is engaged, the voltage on the circuit
varies from 0 V to B+.
Does the voltage measure in the specified range?
| 0 V-B+
| Go to
Step 5
| Go to
Step 4
|
4
|
- Locate an open and/or a high resistance in CKT FU7.
- Repair the open and/or the high resistance in CKT FU7.
Did you complete the repair?
| --
| Go to
Step
9
| --
|
5
|
- Connect all connectors and components that were previously disconnected.
- Replace the LH or the RH turn signal indicator lamp.
Do the LH and RH turn indicators operate properly?
| --
| Go to
Exterior Lights System Check
| Go to
Step 6
|
6
| Replace the instrument
cluster. Refer to
Instrument Cluster Replacement
in Instrument Panel, Gauges and Console.
Did you complete the repair?
| --
| Go to
Step
9
| --
|
7
|
- Disconnect the instrument cluster connector.
- Engage the turn signal switch so that the LH turn indicator is
supposed to be on.
- Use the DMM in order to measure the voltage between terminal 6
of instrument cluster connector and a known good ground.
- When the turn signal switch is engaged, the voltage on the circuit
varies from 0 V to B+.
Does the voltage measure in the specified range?
| 0 V-B+
| Go to
Step 5
| Go to
Step
8
|
8
|
- Locate an open and/or a high resistance in CKT FM13.
- Repair the open and/or the high resistance in CKT FM13.
Did you complete the repair?
| --
| Go to
Step
9
| --
|
9
|
- Connect all connectors and components that were previously disconnected.
- Verify that the LH and RH turn indicator operate properly.
Do the LH and RH turn indicators operate properly?
| --
| Go to
Exterior Lights System Check
| Go to
Step 1
|
