GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Cadillac 🢒 1999 🢒 Catera 🢒 Body and Accessories 🢒 Lighting Systems 🢒 Rear License Plate Lamp Replacement

Removal Procedure

    Object Number: 159432 Size: SH
  1. Remove the rear license plate lamp screws from the rear fascia.

    2. Object Number: 159433 Size: SH
  2. Remove the rear license plate lamp from the rear fascia.
  3. Remove electrical connections.
  4. Remove the protective boot retaining plate (1).
  5. Remove the rubber protective boot to reveal the bulb (2).
  6. Remove the bulb.

Installation Procedure

    Object Number: 159433 Size: SH
  1. Install the bulb.
  2. Install the rubber protective boot (2) over the bulb.
  3. Install the retaining plate (1) to secure the boot.
  4. Install electrical connections.
  5. Install the rear license plate lamp to the rear fascia.

    6. Object Number: 159432 Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  6. Install the rear license plate lamp screws.

    7. Tighten
    Tighten the rear license plate lamp screws until fully seated but not stripped.