- Connect the RH inflatable
restraint front side impact module 2-way connector (if equipped with side
air bags).
- Connect the connector position assurance (CPA) to the RH inflatable
restraint front side impact module 2-way connector (if equipped with side
air bags).
- Connect the passenger seat belt pretensioner 2-way connector to
inline connector C316.
- Install the RH seat track trim cover.
- Connect the LH inflatable restraint front side impact module 2-way
connector (if equipped with side air bags).
- Connect the connector position assurance (CPA) to the LH inflatable
restraint front side impact module 2-way connector (if equipped with side
air bags).
- Connect the driver seat belt pretensioner 2-way connector to inline
connector C315.
- Install the LH seat track trim cover.
- Connect the inflatable restraint IP module 2-way connector (1).
- Connect the connector position assurance (CPA) to the inflatable
restraint IP module 2-way connector.
- Install the inflatable restraint IP module cover. Refer to SIR Module Cover Replacement
.
- Install the inflatable
restraint steering wheel module. Refer to Inflatable Restraint Steering Wheel
Module Replacement.
- Install the upper and lower steering column covers.
- Staying well away from the inflator modules and the pretensioners,
turn the ignition switch to the ON position.
| 14.1. | The AIR BAG warning lamp will flash seven times. |
| 14.2. | The AIR BAG warning lamp will then turn OFF. |
- Perform the SIR Diagnostic system Check if the AIR BAG warning
lamp does not operate as described.
