GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Cadillac 🢒 1999 🢒 Catera 🢒 Steering 🢒 Steering Wheel and Column - Tilt 🢒 Stop Lamp Switch Replacement

Removal Procedure
  1. Remove the driver side closeout insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side in Instrument Panel, Gauges and Console.
  2. Remove the driver side front floor air outlet duct.

    3. Object Number: 219438 Size: SH
  3. Remove the wiring harness connector (1) from the stoplamp switch (2).
  4. Use angled pointed pliers to compress both the locking tabs to remove the stoplamp switch.

Installation Procedure

    Object Number: 219449 Size: SH
  1. Pull both the actuating pin (2) and the retaining collar (1) out of the stoplamp switch to the full extended position of about 17 mm (2/3 in).
  2. Engage the tangs on the stoplamp switch with the brake pedal bracket to install the stoplamp switch to the brake pedal bracket.

    3. Object Number: 219438 Size: SH

    Important: Do not push the actuating pin into the stoplamp switch. The actuating pin self-adjusts to the brake pedal position when the brake pedal returns to the at-rest position.

  3. Install the wiring harness connector (1) to the switch (2).
  4. Install the driver side front floor air outlet duct.
  5. Install the driver side closeout insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side in Instrument Panel, Gauges and Console.