Step
| Action
| Value(s)
| Yes
| No
|
1
| Turn the ignition switch to the ON position (II) to activate the bulb
test. To check the operation of all the bulbs, it is necessary to cycle the
ignition OFF and ON several times or more to complete this test .
- Airbag indicator lamp illuminates for 4 seconds.
- Antilock Brake indicator lamp illuminates for 4 seconds.
- Brake Pad Wear indicator lamp illuminates for 4 seconds.
- Coolant Temperature Gauge indicates current engine temperature.
- Automatic Transmission indicator lamp illuminates for 4 seconds.
- Automatic Transmission Malfunction indicator lamp illuminates
for 4 seconds.
- CHECK ENGINE lamp is ON.
- Fasten Seat Belt indicator lamp is ON. After 4 seconds
the indicator lamp will flash.
- Fuel Gauge indicates current fuel level.
- Coolant Temperature warning lamp illuminates for 4 seconds.
- Low Oil Level indicator lamp illuminates for 4 seconds.
- Low Fuel warning lamp illuminates for 4 seconds.
- Low Coolant level indicator lamp illuminates for 4 seconds.
- Low Washer Fluid indicator lamp illuminates for 4 seconds.
- Oil Pressure indicator lamp is ON.
- Charging indicator lamp is ON.
- BRAKE TO SHIFT indicator lamp is ON.
Do all the warning indicator lamps illuminate?
| --
|
Go to Step 2
| Go to Applicable Diagnostic Table
|
2
|
- Turn ON the ignition switch.
- First operate the LH turn signal then the RH turn signal.
Do the LH and the RH turn indicators flash?
| --
|
Go to Step 3
| Go to the Symptom Table
|
3
|
- Turn ON the ignition switch.
- Pull the turn signal lever towards you to activate FLASH TO PASS.
Does the High Beam indicator illuminate?
| --
|
Go to Step 4
| Go to Exterior Lamps
|
4
|
- Turn ON the ignition switch.
- Apply the Park Brake.
Does the BRAKE indicator illuminate?
| --
|
Go to Step 5
| Go to Applicable Diagnostic Table
|
5
|
- Turn ON the ignition switch.
- Turn the headlamps or parklamps ON and adjust the dimming control.
Does the instrument cluster illumination vary with the dimmer control?
| --
|
Go to Step 6
| Go to Interior Lamps
|
6
| Start the engine and let it idle. The Airbag indicator is ON (not flashing)
during the crank mode. After the engine has started the indicator is ON for
4 seconds then goes OFF.
Does the Airbag indicator operate properly?
| --
|
Go to Step 7
| Go to Restraints
|
7
| Observe the oil pressure gauge with the engine still idling.
Does the gauge read approximately 20 psi?
| --
|
Go to Step 8
| Go to Applicable Diagnostic Table
|
8
| Open the rear compartment lid.
Does the rear compartment lid indicator illuminate?
| --
|
Go to Step 9
| Go to Applicable Diagnostic Table
|
9
|
- Connect the scan tool to the data Link connector (DLC).
- Turn ON the ignition switch.
- Select INSTRUMENT CLUSTER from the menu.
- Attempt to establish communication with the instrument cluster.
| --
|
Go to Step 10
| Go to Scan Does Not Communicate
With Instrument Cluster
|
10
| Are any current DTCs displayed?
| --
| Go to Applicable DTC Table
|
Go to Step 11
|
11
| Are any history
DTCs displayed?
| --
|
Go to Step 12
| System OK
|
12
| Refer to Diagnostic Aids of the DTC that is displayed. Try performing
the test shown while WIGGLING wiring and connectors. This often can cause
the malfunction to occur.
Was a problem found and repaired?
| --
| System OK
| --
|
