Step
| Action
| Value(s)
| Yes
| No
|
1
| Was the Cruise Control System Check performed?
| --
|
Go to Step 2
| Go to
Cruise Control System Check
|
2
|
- Install the scan tool.
- Select CLUTCH/P-N SW from the cruise control data list.
- Turn the ignition switch to the ON position.
- Put the transmission selector into DRIVE and then release the
brake pedal.
Does the scan tool display the specified value?
| Inactive
|
Go to Step 3
|
Go to Step
4
|
3
| Apply the brake pedal.
Does the scan tool display the specified value?
| Active
|
Go to Step 5
|
Go to Step
6
|
4
|
- Disconnect the connector from the cruise control release switch.
- Using a fuse jumper lead, jumper harness terminals 1 and 2.
Does the scan tool display the specified value?
| Inactive
|
Go to Step 6
|
Go to Step
7
|
5
|
- Check for a poor connection at terminal D of the cruise control
module.
- Check the release switch for intermittent sticking.
- Check the cruise control cable for binding or any interference
from other components.
Was a problem found and repaired?
| --
|
Go to Step
8
| --
|
6
| Replace the cruise control release switch.
Is the replacement complete?
| --
|
Go to Step
8
| --
|
7
|
- Locate an open or high resistance in the circuits between the
automatic transmission range switch and terminal D of the cruise control module
connector.
- Repair the open or the high resistance in the circuits between
the automatic transmission range switch and terminal D of the cruise control
module connector.
- Replace the cruise control module if these circuits are OK.
Is the repair or replacement complete?
| --
|
Go to Step 8
| --
|
8
|
- Connect all connectors and components that were disconnected.
- Verify that the cruise control disengages properly.
Does the cruise control disengage properly?
| --
| System OK
| Go to
Cruise Control System Check
|
