Did you perform the Instrument Cluster System Check?

--

Go to Step 2

Go to Instrument Cluster System Check

1. Install the scan tool.
2. Select SPECIAL FUNCTIONS from the INSTRUMENT CLUSTER menu.
3. Command the coolant temperature gauge from H to C.

Does the gauge respond when commanded?

--

Go to Step 3

Go to Step 4

1. Disconnect C105.
2. Turn ON the ignition switch.
3. Use a DMM in order to measure the voltage at terminal 11.

Is the voltage within the specified range?

B+

Go to Step 5

Go to Step 6

Replace the instrument cluster. Refer to Instrument Cluster Replacement .

Is the replacement complete?

--

Go to Instrument Cluster System Check

--

Inspect between terminal 11 of C105 and terminal 1 of C115 for an open circuit.

Did you find and repair a circuit problem?

--

Go to Step 8

Go to Step 7

Locate and repair an open circuit.

Did you find and repair a circuit problem?

--

Go to Step 8

Go to Step 4

Replace the engine coolant temperature gauge sensor.

Is the replacement complete?

--

Go to Step 8

--

1. Connect all connectors and components that were removed in previous steps.
2. Verify that the coolant temperature gauge operates properly.

Does the coolant temperature gauge operate properly?

--

System OK

Go to Step 2