Circuit Description
Modules connected to the Class 2 data link monitor the link for serial data communications during normal vehicle operation. Operating information (Report messages) and commands (Load messages) are exchanged among the modules. When a module receives a Report or Load message for a critical operating parameter, the module records the Source ID of the module which sent the message for State of Health monitoring (Node Alive messages). A critical operating parameter is one which, when not received, requires that the module use a default value for that parameter. Once a Source ID is learned by a module, it will monitor for that Source ID's NODE ALIVE message. Each module on the Class 2 data link which is powered and performing functions that require detection of communications malfunction is required to send a NODE ALIVE message every two seconds. When no message is detected from a learned Source ID for five seconds, a DTC U1128 is set.
Conditions for Setting the DTC
| • | The voltage supplied to the module is in the normal operating voltage range (approximately 9-16 volts). |
| • | DTC U1300 and DTC U1301 are not current |
| • | A message from a learned Source ID has not been detected for the past five seconds |
Conditions for Clearing the DTC
| • | A current DTC U1128 will clear when a NODE ALIVE message from the failed Source ID is detected on the data link or at the end of the current ignition cycle. |
| • | A history DTC U1128 will clear upon receipt of a scan tool CLEAR DTCs command. |
Test Description
The number(s) below refer to the step number(s) on the diagnostic table.
-
A module which loses power during an ignition cycle will cause other module(s) to set Lost Communication DTCs.
-
This step inspects for a poor connection to the radio receiver preventing serial communication.
-
The module which was not communicating due to an open in the Class 2 serial data circuit may have Lost Communication DTCs for those modules that it was monitoring.
-
The module which can communicate, BCM and RCDLR (if equipped) indicates the module (the Radio) which cannot communicate. It is necessary to clear the DTCs from these modules to avoid future misdiagnosis.
Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
Was a repair made when the Radio Diagnostic System Check was performed? | -- | |||
Did you find and correct the condition? | -- | |||
3 |
Does the scan tool display any DTCs which do not begin with a "U"? | -- | Go to the Applicable DTC Table | |
4 | Measure the resistance of the serial data circuit from the radio receiver terminal F6 to the data link connector (DLC) terminal 2. Does the resistance measure less than the specified value? | .5 ohms | ||
5 | Clear the DTCs using the scan tool. Did you complete the action? | -- | -- | |
6 |
Did you complete the replacement? | -- | -- | |
7 | Locate and repair an open or high resistance in the serial data circuit between the radio and the DLC. Did you find and correct the condition? | -- | -- | |
8 | Select the Display DTCs function for the module(s) which had the Lost of Communications With IRC DTC set. Does the scan tool display any DTCs which do not begin with a "U"? | -- | Go to the Applicable DTC Table | |
Did you complete the action? | -- | System OK | -- |
