Circuit Description
This DTC identifies a malfunction within the electronic brake control module (EBCM).
Conditions for Running the DTC
The ABS conditions and the braking conditions are normal.
Conditions for Setting the DTC
An internal EBCM malfunction exists.
Action Taken When the DTC Sets
C1255
If equipped, the following actions occur:
| • | The EBCM disables the ABS/DRP/EDC/TCS/VSES for the duration of the ignition cycle. |
| • | The EBCM disables the variable effort steering (VES) for the duration of the ignition cycle. |
| • | The ABS indicator turns ON. |
| • | The Traction Off indicator turns ON. |
| • | The red Brake warning indicator turns ON. |
| • | The DIC displays the Service Stability System message. |
| • | The EBCM will also set DTC C1248. |
C1256
| • | The ABS remains functional. |
| • | The ABS indicator remains OFF. |
Conditions for Clearing the DTC
| • | The condition for the DTC is no longer present and the DTC is cleared with a scan tool. |
| • | The electronic brake control module (EBCM) automatically clears the history DTC when a current DTC is not detected in 100 consecutive drive cycles. |
Diagnostic Aids
The scan tool displays 2 additional characters after the DTC. Take note of the 2 character code and any other DTCs that are set. The 2 character code is an engineering aid used in order to determine the cause of the internal malfunction.
Test Description
The number below refers to the step number on the diagnostic table.
Step | Action | Yes | No |
|---|---|---|---|
Schematic Reference: Antilock Brake System Schematics | |||
1 | Did you perform the ABS Diagnostic System Check? | Go to Step 2 | |
Does the DTC reset as a current DTC? | Go to Step 3 | Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems | |
3 | Replace the EBCM. Refer to Electronic Brake Control Module Replacement . Did you complete the repair? | Go to Step 4 | -- |
4 |
Does the DTC reset? | Go to Step 2 | System OK |
