Tools Required

J 3049-A Valve Lifter Remover

1. Remove the cylinder head. Refer to Cylinder Head Replacement - Left Side or Cylinder Head Replacement - Right Side .
2. Remove the valve lifter guide bolts (1).
3. Remove the valve lifters and guide.




Important: Some valve lifters may be stuck in their bores because of gum or varnish deposits.

4. Use the J 3049-A or equivalent in order to remove the valve lifters (if required).



5. Remove the valve lifters from the guide.
6. Organize or mark the components so that they can be installed in the same location from which they were removed.
7. Clean and inspect the valve lifters and guides. Refer to Valve Lifters and Guides Cleaning and Inspection .

Important: When reusing valve lifters, install the lifters to their original locations.

1. Lubricate the valve lifters and engine block valve lifter bores with clean engine oil.
2. Insert the valve lifters into the lifter guides.

Align the flat area on the top of the lifter with the flat area in the guide bore. Push the lifter completely into the guide bore.




3. Install the valve lifters and guide to the engine block.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

4. Install the valve lifter guide bolt (1).

Tighten
Tighten the valve lifter guide bolt to 12 N·m (106 lb in).

5. Install the cylinder head. Refer to Cylinder Head Replacement - Left Side or Cylinder Head Replacement - Right Side .