Clutch Concentric Actuator Cylinder Replacement CTS

1. Remove the transmission. Refer to Transmission Replacement in Manual Transmission - M35.
2. Remove the concentric slave cylinder quick connect bolt (5).
3. Remove the 3 concentric slave cylinder bolts (1).
4. Remove the concentric slave cylinder (2).
5. Remove the O-ring (3).

1. Install the O-ring (3).
2. Install the concentric slave cylinder (2).

Notice: Refer to Fastener Notice in the Preface section.

3. Install the 3 concentric slave cylinder bolts (1) and the quick connect bolt (5).

Tighten:

•	Tighten the 3 concentric slave cylinder bolts (1) to 20 N·m (15 lb ft).

•	Tighten the quick connect bolt (5) to 10 N·m (89 lb in).

4. Install the transmission. Refer to Transmission Replacement in Manual Transmission - M35.

Clutch Concentric Actuator Cylinder Replacement CTS-V

1. Remove the transmission. Refer to Transmission Replacement . The transmission removal procedure includes the removal of the concentric actuator cylinder from the transmission.



2. Remove the clip from the line connection at the front of the dash. The graphic shows the view from the top of the engine for clarity.
3. Separate the hydraulic line connection and remove the concentric actuator cylinder from the vehicle.
4. Cap the vehicle hydraulic line to prevent contamination of the system.

1. Install the concentric actuator cylinder to the vehicle.
2. Install the concentric actuator cylinder connector to the vehicle hydraulic line.
3. Force the line connection together while installing the clip to the hydraulic line connection.
4. Carefully pull the lines apart to ensure there is a proper connection.



5. Install the transmission. Refer to Transmission Replacement .
6. Bleed the hydraulic clutch system. Refer to Hydraulic Clutch Bleeding .