Schematic Reference: Navigation System Schematics

DEFINITION: When playing a video input source connected to the auxiliary RCA video jacks, the video audio is inoperative, plays one side only or is degraded.

Did you perform Diagnostic System Check - Navigation System?

Go to Step 2

Go to Diagnostic System Check - Navigation System

1. Turn ON the ignition with the engine OFF. The Cadillac emblem screen appears on the navigation radio.
2. Leave the vehicle in PARK.
3. Press the MAIN button on the radio. The main menu appears on the display.
4. Press the TV button on the main menu screen.
5. Select a TV station. The TV should be clear on the radio display.
6. Connect a VCR to the auxiliary RCA video jacks.
7. Select AUX VIDEO under the TV SETUP menu screen.
8. Observe the display. The VCR selection should appear on the radio. The picture and audio should be clear.

Does the system operate normally?

Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems

Go to Step 3

Operate the TV function of the navigation system.

Does the audio for the TV function operate with good quality?

Go to Step 4

Go to Symptoms - Navigation Systems

Test the following circuits for an open, a short to ground or a short to voltage.

Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 10

Go to Step 5

Test for a short between the auxiliary audio left signal circuit to the auxiliary audio right signal circuit. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 10

Go to Step 6

Inspect for poor connections at the harness connector of the auxiliary RCA video jacks. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 10

Go to Step 7

Replace the auxiliary RCA video jacks. Refer to Auxiliary Audio/Video Input Control Replacement .

Did you find and correct the condition?

Go to Step 10

Go to Step 8

Inspect for poor connections at the harness connector of the TV antenna module. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 10

Go to Step 9

Replace the TV antenna module. Refer to Television Antenna Module Replacement .

Did you complete the replacement?

Go to Step 10

--

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 3