Removal Procedure
- Disconnect the following from the intake resonance switchover solenoid:
• | The electrical connector |
| Important: Observe the proper positions of the vacuum hoses.
|
- Remove the intake resonance switchover solenoid screws.
- Remove the intake resonance switchover solenoid from the intake air resonator.
Installation Procedure
- Position the intake resonance switchover solenoid to the intake air resonator.
Notice: Refer to Fastener Notice in the Preface section.
- Install the intake resonance switchover solenoid screws.
Tighten
Tighten the intake resonance switchover solenoid screws to 3 N·m (27 lb in).
- Connect the following to the intake resonance switchover solenoid:
• | The electrical connector |
| Important: Properly position the vacuum hoses as previously noted during removal.
|