Brake Warning Indicator Inoperative Buick
Step | Action | Value(s) | Yes | No | ||||
|---|---|---|---|---|---|---|---|---|
1 | Was the entire Brake Warning System Check performed? | -- | ||||||
2 | Did the BRAKE indicator illuminate briefly during the bulb check (when the ignition switch transitions from RUN to START)? | -- | ||||||
3 |
Is the test lamp lit? | -- | ||||||
4 | Connect the test lamp between the connector terminals C and B. Is the test lamp lit? | -- | ||||||
5 | Connect the test lamp between the connector terminal B and ground. Is the test lamp lit? | -- | ||||||
6 | Repair circuit 875 (LT GRN/BLK) for a short to positive voltage. Is the repair complete? | -- | -- | |||||
7 | Repair open in circuit 875 (LT GRN/BLK). Is the repair complete? | -- | -- | |||||
8 |
Is the test lamp lit? | -- | ||||||
9 | Connect the fused jumper between the harness connector C1, terminal E16 and battery positive voltage. Is the test lamp lit? | -- | ||||||
10 | Connect the fused jumper between the harness connector C1, terminal E16 and ground. Is the test lamp lit? | -- | ||||||
11 | Repair short to positive voltage in circuit 33 (TAN/WHT). Is the repair complete? | -- | -- | |||||
12 | Repair open in circuit 875 (LT GRN/BLK). Is the repair complete? | -- | -- | |||||
13 | Repair open in circuit 39 (PNK). Is the repair complete? | -- | -- | |||||
14 | Replace the brake fluid level switch. Is the repair complete? | -- | -- | |||||
15 | Check the instrument cluster BRAKE indicator and circuit for an open.
Is repair complete? | -- | -- | |||||
16 |
Is the test lamp lit? | -- | ||||||
17 | Replace the park brake switch. Is the repair complete? | -- | -- | |||||
18 | Repair open in circuit 33 (TAN/WHT). Is the repair complete? | -- | -- |
Brake Warning Indicator Inoperative Oldsmobile
Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
1 | Did you perform the Brake Warning System Check? | -- | Go to Step 2 | |
2 | Did the PARK indicator illuminate briefly during the bulb check (when the ignition switch transitions from RUN to START)? | -- | Go to Step 3 | Go to Step 4 |
3 | Did the PARK indicator illuminate when the park brake was applied? | -- | Go to Step 11 | Go to Step 9 |
4 |
Is the voltage within the specified range? | 10-15V | Go to Step 20 | Go to Step 5 |
5 | Connect the DMM between the connector terminal B11 and ground. Is the voltage within the specified range? | 10-15V | Go to Step 6 | Go to Step 16 |
6 |
Is the resistance less than the specified range? | 5 ohms | Go to Step 7 | Go to Step 8 |
7 | Repair open in CKT 33 (TAN/WHT) between C202 and the ignition switch. If the circuit is open, test for a short to positive voltage. Did you complete the repair? | -- | -- | |
8 | Repair open in CKT 33 (TAN/WHT) between C202 and the instrument cluster. If the circuit is open, test for a short to positive voltage. Did you complete the repair? | -- | -- | |
9 |
Is the measured voltage within the specified range? | 10-15V | Go to Step 17 | Go to Step 10 |
10 | Repair open in CKT 33 (TAN/WHT) between S226 and the park brake switch. If the circuit is open, test for a short to positive voltage. Did you complete the repair? | -- | -- | |
11 |
Is the measured voltage within the specified range? | 10-15V | Go to Step 18 | Go to Step 12 |
12 |
Is the measured voltage within the specified range? | 10-15V | Go to Step 19 | Go to Step 13 |
13 |
Is the measured voltage within the specified range? | 10-15V | Go to Step 21 | Go to Step 14 |
14 |
Is the measured voltage within the specified range? | 10-15V | Go to Step 15 | Go to Step 16 |
15 | Repair open in CKT 33 (TAN/WHT). If the circuit is open, test for a short to positive voltage. Did you complete the repair? | -- | -- | |
16 | Repair open in CKT 39 (PNK). If the circuit is open, test for a short to positive voltage. Did you complete the repair? | -- | -- | |
17 | Replace the park brake switch. Did you complete the repair? | -- | -- | |
18 | Replace the brake fluid level sensor. Did you complete the repair? | -- | -- | |
19 | Repair open in CKT 875 (LT GRN/BLK). If the circuit is open, test for a short to positive voltage. Did you complete the repair? | -- | -- | |
20 | Check instrument cluster PARK indicator and the circuit for an open. Did you complete the repair? | -- | -- | |
21 | Check instrument cluster BRAKE FLUID indicator and the circuit for an open. Did you complete the repair? | -- | -- |
