Did you perform the Charging System Check ?

--

Go to Step  2

Go to Charging System Check .

1. Turn the ignition switch to RUN.
2. Observe the charge indicator during bulb check.

Does the charge indicator turn on during bulb check?

--

Go to Step  3

Go to Step  5

1. Disconnect the generator connector.
2. Attach a fused jumper between the generator connector terminal B and ground.
3. Turn the ignition switch to RUN.

Does the charge indicator turn on within two minutes?

--

Go to Step  4

Go to Step  6

Check the generator. Refer to Generator Not Operating Properly

Is the repair complete?

--

Go to Step  9

--

Replace the instrument cluster. Refer to Instrument Cluster Replacement .

Is the repair complete?

--

Go to Step  9

--

Check CKT 225 (RED) for an open.

Is the circuit OK?

--

Go to Step  8

Go to Step  7

Repair CKT 225 (RED).

Is the repair complete?

--

Go to Step  9

--

1. Check the powertrain control module (PCM) connectors foe poor terminal contact.
2. If OK, replace the PCM. Refer to Powertrain Control Module Replacement/Programming in Engine Controls - 3.8L OR Powertrain Control Module Replacement/Programming in Engine Controls -4.0L, 4.6L.

Is the repair complete?

--

Go to Step  9

--

1. Make sure any components removed during diagnosis are installed in place and the all connectors are connected.
2. Repeat the system check. Refer to Charging System Check .

Is the system check complete?

--

System OK

--