For 1990-2009 cars only
- Install the turn signal and multifunction switch assembly. Use the 2 tapping screws in order to secure the assembly.
- Install the turn signal and multifunction switch connector (2) to the bulk head connector (1).
- Connect the wire harness assembly to the wire harness strap (1).
- Install the upper cover and the lower cover. Refer to Steering Column Trim Covers - Assemble - Off Vehicle
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the screws to 0.5 N·m (5 lb in).
