The SIR scan tool data definitions contain a brief description
of all SIR related parameters available on the scan tool. The parameters that
are available on the scan tool are listed below in alphabetical
order.
8 Digit GM Part Number: The scan tool displays the GM part number that is stored within
the SDM memory.
Calibration ID: The scan tool displays the calibration ID, which is the check sum
of the SDM read only memory contents.
Component Serial Number: The scan tool displays the SDM component serial number that is
stored within the SDM.
Driver Frontal Loop: The scan tool displays whether the inflatable restraint steering
wheel module deployment loop is enabled or disabled.
Driver Side Belt Status: The scan tool displays whether the driver seat is buckled or unbuckled.
Ignition Voltage: The scan tool displays 0 - 20 volts. This is the system
voltage maesured by the SDM between the ignition input and ground.
Julian Date of Build: The scan tool displays a 3 digit number. An example would
be 723. 723 is July 23 which is day 204 based on the Julian
Calendar.
Lamp in Current State: The scan tool displays the number of cycles that the AIR BAG indicator
has been turned ON.
Passenger Frontal Loop: The scan tool displays whether the inflatable restraint IP module
deployment loop is enabled or disabled.
Passenger Side Belt Status: The scan tool displays whether the passenger seat belt is buckled
or unbuckled.
PROM ID: The scan tool displays the programmable read-only memory (PROM)
ID.
Warning Lamp ON/OFF Timer: The scan tool displays, in minutes, that the AIR BAG indicator
has been turned ON.
Year Module Built: The scan tool displays what year the module was built.