Automatic Transmission Shift Lock Control Actuator Replacement Floor Shift

1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection in Engine Electrical.
2. Remove the center console. Refer to Front Floor Console Replacement in Instrument Panel, Gauges, and Console.



3. Disconnect electrical connector from the shift lock control (2) for the automatic transmission (AT).



4. Remove both ends of the AT shift lock control from pivot points (1).

1. Install the upper clip of the AT shift lock control onto the upper pivot point, and the lower clip onto the lower pivot point.
2. Install the center console. Refer to Front Floor Console Replacement in Instrument Panel, Gauges, and Console.
3. Install the electrical connector to the AT shift lock control.
4. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection in Engine Electrical.

Automatic Transmission Shift Lock Control Actuator Replacement Column Shift

1. Remove the steering column trim covers. Refer to Steering Column Trim Covers Replacement - On Vehicle .



2. Remove the knee bolster.
3. Remove the shift lever actuator. Refer to Shift Lever Replacement - On Vehicle .
4. Disconnect the electrical connector from the automatic shift lock control actuator.
5. Remove the automatic shift lock control actuator from the steering column ball studs.

1. Install the automatic shift lock control actuator onto the steering column ball studs.
2. Connect the electrical connector to the automatic shift lock control actuator.
3. Install the shift lever actuator. Refer to Shift Lever Replacement - On Vehicle . Place the column in the neutral position.



4. Adjust the automatic shift lock control actuator.

•	Pull out the tab (1) on the adjuster block side (2) of the actuator.

•	Press on the adjuster block (2) in order to compress the internal adjuster spring and disengage the adjuster teeth. Slide the adjuster block as far away from the actuator as possible.

•	Lock in place by pushing in on the tab (1).

5. Inspect the actuator.

•	The actuator must lock the shift lever clevis when you place the clevis in the park position.

•	If you can move the shift lever without pressing on the brake pedal, readjust the actuator.

6. Install the steering column trim covers. Refer to Steering Column Trim Covers Replacement - On Vehicle .
7. Install the knee bolster.