Crankshaft Position Sensor Replacement 7x

1. Turn OFF the ignition.
2. Crank steering wheel fully to the left.
3. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
4. Remove the right tire and wheel. Refer to Tire and Wheel Removal and Installation in Tire and Wheel.
5. Disconnect the sensor electrical connector.
6. Remove the attaching bolt/screw.
7. Remove the sensor from engine.
8. Inspect for wear, cracks, or leakage if the sensor is not being replaced.

1. Lubricate the O-ring with clean engine oil before installation and replace if damaged.



2. Install the sensor to the block.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the sensor attaching bolt.

Tighten
Tighten the bolt to 11 N·m (97 lb in).

4. Connect the sensor electrical connector.
5. Install the right tire and wheel. Refer to Tire and Wheel Removal and Installation in Tire and Wheel.
6. Lower the vehicle.
7. Perform the CKP System Variation Learn Procedure. Refer to Crankshaft Position System Variation Learn .