Connect a Scan Tool and check for powertrain control module (PCM) DTCs.

Are any PCM DTCs set?

--

Go to Powertrain On Board Diagnostic (OBD) System Check in Engine Controls - 3.1L or Powertrain On Board Diagnostic (OBD) System Check in Engine Controls - 3.8L

Go to Step 2

1. Turn the ignition switch to the RUN position with the engine off.
2. Press and hold the odometer trip reset button for approximately 12 seconds.

Does the change oil indicator flash twice and then turn off?

--

Go to Step 3

Go to Step 5

Turn the ignition switch to the RUN position.

Does the change oil indicator illuminate for approximately 60 seconds and then turn off?

--

Go to Powertrain On Board Diagnostic (OBD) System Check in Engine Controls - 3.1L or Powertrain On Board Diagnostic (OBD) System Check in Engine Controls - 3.8L

Go to Step 4

1. Connect a Scan Tool to the vehicle data link connector (DLC).
2. WOW the instrument cluster ON.

Does the change oil indicator turn ON?

--

System OK

Go to Step 5

Replace the instrument cluster. Refer to Instrument Cluster Replacement .

Is the repair complete?

--

System OK

--