GM Service Manual Online
For 1990-2009 cars only

Step

Action

Value(s)

Yes

No

1

  1. Using a test light, backprobe between connector C205 terminal G to ground.
  2. Turn the ignition switch on.

Is the test light on?

--

Go to Step 3

Go to Step 2

2

Repair poor connection or open in circuit 43.

Is the repair complete?

--

Go to Steering Wheel Control System Check

--

3

  1. Disconnect C205.
  2. Connect a J 39200 Digital Multimeter (DMM) between C205 (female side) terminal G and terminal H.
  3. Press each of the Left steering wheel control buttons one at a time.
  4. Compare the approximate resistance values to the list below:
  5. • Volume Up: 1270ohms
    • Volume Down: 1564ohms
    • Seek Up: 3102ohms
    • Prog: 13632ohms

Do all the resistance values approximately equal those above?

--

Go to Step 7

Go to Step 4

4

  1. Disconnect the Left radio control switch.
  2. Connect a J 39200 DMM between the left radio control switch pigtail harness connector terminal G and terminal H.
  3. Press each of the Left steering wheel control buttons, one at a time.
  4. Compare the approximate resistance values to the list below:
  5. • Volume Up: 1270ohms
    • Volume Down: 1564ohms
    • Seek Up: 3102ohms
    • Prog: 13632ohms

Do all the resistance values approximately equal those above?

--

Go to Step 6

Go to Step 5

5

Replace the Left radio control switch. Refer to Steering Wheel Control Switches Replacement .

Is the repair complete?

--

Go to Steering Wheel Control System Check

--

6

Replace the inflatable restraint steering wheel module coil. Refer to Inflatable Restraint Steering Wheel Module Coil Replacement in SIR.

Is the repair complete?

--

Go to Steering Wheel Control System Check

--

7

  1. Using a test light, backprobe between the radio harness connector terminal E6 to ground.
  2. Turn the ignition switch on.

Is the test light on?

--

Go to Step 8

Go to Step 9

8

Repair short to B+ on circuit 1796.

Is the repair complete?

--

Go to Steering Wheel Control System Check

--

9

Using a J 39200 DMM, measure the resistance between the radio harness connector terminal E6 and ground.

Is the resistance measured equal to the specified value?

Go to Step 11

Go to Step 10

10

Repair short to ground in circuit 1796.

Is the repair complete?

--

Go to Steering Wheel Control System Check

--

11

Check for poor connection or open in circuit 1796.

Is there a poor connection or open in circuit 1796?

--

Go to Step 12

Go to Step 13

12

Repair poor connection or open in circuit 1796.

Is the repair complete?

--

Go to Steering Wheel Control System Check

--

13

Service the radio. Refer to Radio Replacement .

Is the repair complete?

--

Go to Steering Wheel Control System Check

--