Removal Procedure
- Remove the front cover. Refer to Engine Front Cover Replacement .
- Remove the oil filter adapter. Remove the pressure regulator valve and the spring. Refer to Oil Filter Adapter and Bypass Valve Assembly Replacement .
- Remove the oil pump cover attaching screws.
- Remove the oil pump cover.
Installation Procedure
- Install the oil pump cover.
- Install the oil pump cover screws.
- Install the oil filter adapter with a new gasket. Install the pressure regulator valve and the spring. Refer to Oil Filter Adapter and Bypass Valve Assembly Replacement .
- Install the front cover. Refer to Engine Front Cover Replacement .
- Inspect the oil pressure.
- Inspect for the proper fluid levels.
- Inspect for leaks.
Tighten
Tighten the oil pump cover attaching screws to 11 N·m (98 lb in).
Refer to
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
in General Information.Notice: Do not run the engine until the oil pressure is tested. Running the engine without measurable oil pressure will cause extensive damage.
Notice: Stop the engine and remove the oil pan if the oil pressure does not build up immediately. Check the oil pump pipe and the screen for a clogged screen, damaged pipe, or a damaged gasket. Running the engine without measurable oil pressure will cause extensive damage.
