Circuit Description
The theft deterrent control module checks memory to see if the learn coded key setting is on. If so, the theft deterrent control module sets this DTC.
DTC Descriptor
This diagnostic procedure supports the following DTC:
DTC B3031 Security System Controller In Learn Mode
Conditions for Running the DTC
The microprocessor runs the program to detect a check sum error after each power up. This program runs only if the DTC B1982 or B1983 are not set as a current DTCs.
Conditions for Setting the DTC
If the learn coded key setting is on, the theft deterrent control module sets this DTC.
Action Taken When the DTC Sets
The theft deterrent control module will learn the key code. The security indicator will be illuminated for this DTC.
Conditions for Clearing the MIL/DTC
The theft deterrent control module clears the current status of the DTC when it does not see the learn coded key setting as on. The DTC will still be retrieved as current until the ignition switch is cycled. The DTC will become a history DTC at that time.
Test Description
The number below refers to the step number on the diagnostic table.
Step | Action | Yes | No |
|---|---|---|---|
Schematic Reference: Theft Deterrent System Schematics Connector End View Reference: Theft Deterrent System Connector End Views | |||
1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | Go to Diagnostic System Check - Vehicle in Vehicle DTC Information |
|
Important: If a 10 minute or 30 minute re-learn procedure is performed, all keys not learned at that time will be erased and will not be recognized. Perform the adding keys procedure on all keys or instruct the customer how to perform the adding keys procedure. Refer to Adding Keys . Perform the programming theft deterrent system components procedure. Refer to Programming Theft Deterrent System Components . Is the procedure complete? | Go to Step 3 | -- | |
3 |
Does the DTC reset? | Go to Step 2 | System OK |
