Circuit Description
The seat belt tower uses the memory seat module (MSM) to move seat belt tower up, down, back to memory position. When vehicle is not equipped wih memory seats then a separte seat belt switch controls the seat belts towers.
Diagnostic Aids
| • | The following conditions may result in an intermittent operation of the module with no DTC stored: |
| - | Any condition which results in the interruption of power to the MSM |
| - | Out of range battery or ignition voltage |
Specification
Normal MSM operating voltage: 9.0-16.0 V
| - | A loose or damaged ground(s) |
| - | An open or shorted serial data line |
| • | An intermittent failure in the electronic system may be difficult to detect and to diagnose. The MSM tests for different malfunctions under different vehicle conditions. For this reason, a thorough test drive is often needed in order to repeat a malfunction. If the system malfunction is not repeated during the test drive, a good description of the complaint may be useful in locating an intermittent malfunction. Faulty electrical connections or wiring causes most intermittent problems. When an intermittent condition is suspected, check the suspected circuits for the following conditions: |
| - | Poor mating of connector halves or backed out terminals |
| - | Improperly formed or damaged terminals |
| - | Wire chafing |
| - | Poor wire to terminal connections |
| - | Dirty or corroded terminals |
| - | Damage to connector bodies |
| • | Use the J 35616 whenever a diagnostic procedure requests probing or checking a terminal. Using this adapter will ensure that no damage to the terminal will occur, and will give an idea of whether contact tension is sufficient. |
| • | If the DTC is a history DTC, the problem may be intermittent. Perform the tests shown while moving related wiring and connectors. This car often cause the malfunction to occur. Perform a thorough inspection of all related wiring and connectors pertaining to the history DTC stored. |
| • | Exit all scan tool tests before cycling the ignition OFF to ON unless the scan tool instructions direct otherwise. |
Test Description
The numbers below refer to the step numbers on the diagnostic table.
-
Lack of communication may be due to a partial malfunction of the Class 2 serial data circuit or due to a total malfunction of the class 2 serial data circuit. The specified procedure will determine the particular condition.
-
The Symptom Table will determine the correct diagnostic procedure to use.
-
The presence of DTCs which begin with "U" indicate some other module is not communicating. The specified procedure will compile all the available information before tests are performed.
-
This step determines if any internal controller DTCs are set.
-
This steps determines if any system voltage DTCs are set.
Step | Action | Yes | No |
|---|---|---|---|
1 |
Does the scan tool power up? | Go to Step 2 | Go to Scan Tool Does Not Power Up in Data Link Communications |
Does the scan tool communicate with the Memory Seat Module? | Go to Step 3 | Go to Scan Tool Does Not Communicate with Class 2 Device in Data Link Communications | |
Select the Memory Seat Module display DTC function on the scan tool. Does the scan tool display any DTCs? | Go to Step 4 | Go to Symptoms - Seat Belts | |
Does the scan tool display any DTCs which begin with a U? | Go to Scan Tool Does Not Communicate with Class 2 Device in Data Link Communications | Go to Step 5 | |
Does the scan tool display DTC B1000, B1004, B1007, or B1009? | Go to Diagnostic Trouble Code (DTC) List in Body Control System | Go to Step 6 | |
Does the scan tool display DTC B1982 or B1983? | Go to Diagnostic Trouble Code (DTC) List in Engine Electrical |
