Tools Required

1. Disable the SIR system. Refer to Disabling the SIR System in Restraints.
2. Remove the Inflatable Restraint Steering Wheel Module. Refer to Inflatable Restraint Steering Inflator Module-SIR Replacement in Restraints.
3. Remove the nut.
4. Note the mark on the steering shaft and the steering wheel in order to ensure proper alignment during installation.
5. Use the J 42578 and the J 1859-A in order to remove the steering wheel .
6. Remove the J 42578 and the J 1859-A from the steering wheel.

1. Route the wiring through the steering wheel.
2. Align the mark on the steering wheel with the mark on the shaft.
3. Install the steering wheel.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

4. Install the nut.

Tighten
Tighten the nut to 41 N·m (30 lb ft).

5. Install the Inflatable Restraint Steering Wheel Module. Refer to Inflatable Restraint Steering Inflator Module-SIR Replacement in Restraints.
6. Enable the SIR system. Refer to Enabling the SIR System in Restraints.