Removal Procedure
- Use a braided wire or a thin bladed tool inserted between the molding and the sheet metal in order to split the foam tape.
- Use 3M General Purpose Adhesive Cleaner 08984 or the equivalent in order to remove the old adhesive from the panel and the molding (if reusing).
Important: If using a bladed tool, protect the surrounding surfaces. Do not damage the paint.
Notice: If tape is still intact on the molding or panel, do not remove the tape. Clean the tape and the mating surface with Adhesive Cleaner. Wipe the tape and mating surface with a clean, soft cloth. If the tape is damaged, refer to Emblem/Nameplate Replacement.
Important: Do not use rotating adhesive removal discs on the moldings. The rotating discs generate excessive heat. Excessive heat may cause molding damage.
Use 3M Scotch-Brite Adhesive Removal Discs on the body panels.
Installation Procedure
- If reusing the molding, apply new adhesive tape to the molding.
- Align the molding. Mark a reference on the body as needed. Use masking tape in order to aid alignment once the adhesive liner is removed.
- Align the molding.
- Press the molding to the fender.
Remove the backing from the adhesive tape.
Important: Wear clean gloves or use a clean towel while performing this step.
Assure proper wetout of the adhesive by applying heavy hand pressure against the molding at the upper and the lower tape locations. Rub along the entire length of the molding.
