The rear end panel is supplied as a complete assembly. The tail lamp pockets are attached to the quarter panels.

1. Remove all related panels and components.
2. Visually inspect and restore as much of the damage as possible to factory specifications.
3. Locate, mark and drill out all the factory welds.
4. Remove the damaged section of the rear end panel.

1. Position the service panel and check fit.
2. Plug weld accordingly.
3. Clean and prepare welded surfaces.
4. Apply sealers and anti-corrosion materials as necessary.
5. Prime with two-part catalyzed primer.
6. Install all related panels and components.