Removal Procedure
- Remove the mirror and
plastic backing plate (7) by pulling the assembly out of the mirror
housing (1).
- Verify that the springs (5) on the actuator shafts are
not pushed down on the shafts.
- Ensure that the springs (5) are seated in the grooves.
- Disconnect the electrical connectors.
Installation Procedure
- Snap the actuator shafts
into the power drive unit (8).
- Connect the electrical connectors.
- Rotate the actuator shafts in order to align the ears with the
corresponding slots in the back side of the mirror face (7).
- Align the swivel (3) on the power drive unit (8)
to the pivot points on the mirror backing plate.
- To avoid damaging electrochromatic mirrors, yellowing and/or silver
delamination, pressure must not be applied to the center of the mirror. Place
a 6 x 9 cm (2 x 3 in) block of wood
in the indicated target area. This will distribute pressure evenly.
- Hold the block against the mirror face while you perform the following
procedures:
| 6.1. | Push in on the block (6) until you hear a snap. |
| 6.2. | Tilt the mirror (7) toward the upper actuator shaft (2).
Apply pressure until the ratchet sound stops. |
| 6.3. | Tilt the mirror (7) toward the outside of the actuator
shaft (4). |
| 6.4. | Apply pressure on the block until the ratchet sound stops. |
- Inspect the mirror for the proper operation. If the mirror is
not operating properly, inspect the actuator shaft alignments again.
