1. Turn the ignition switch to the ON position.
2. Ensure that the radio is OFF.

The radio displays the current time.

Radio Display Inoperative, No Sound from Speakers

Turn the radio ON.

The radio displays a current station for approximately 5 seconds and then the current time.

Radio Display Inoperative, No Sound from Speakers

Turn the headlamp switch to the PARK position.

Interior Lights Dimming System Check

1. Turn the FADE control to the front speakers.
2. Turn the balance control to the left front speaker and then to the right front speaker.

1. Turn the FADE control to the rear speakers.
2. Turn the balance control to the left rear speaker and then to the right rear speaker.
3. Return the fade and balance control to the neutral position.

Press the RECALL button.

The radio display toggles between the tuner and the clock.

Radio Control Inoperative,

refer to Radio Replacement

Adjust BASS control to the high and low position.

The music attenuates between high and low bass frequencies.

Radio Control Inoperative,

refer to Radio Replacement

Adjust TREB control to the high and low position.

The music attenuates between high and low treble frequencies.

Radio Control Inoperative,

refer to Radio Replacement

Return BASS and TREB control buttons to the neutral position.

The music returns to nominal bass and treble frequencies.

Radio Control Inoperative,

refer to Radio Replacement

Press the AUTO TONE button 7 times.

Auto tone cycles through the following presets:

Radio Control Inoperative,

refer to Radio Replacement

Press up the BAND button in order to access the FM1 and FM2 bands.

The radio stations on the FM1 and FM2 bands appear on the display.

Radio Control Inoperative,

refer to Radio Replacement

Press the BAND button down in order to access the AM band.

The radio stations on the AM band appear on the display.

Radio Control Inoperative,

refer to Radio Replacement

Press and hold the SCAN button for 2-3 seconds.

Each of the presets are scanned for a few seconds and continues until the button is pressed again.

Radio Control Inoperative,

refer to Radio Replacement

Press and hold HR or MIN until the time display begins to change.

The time display begins to move. There is approximately a 2 second delay before the clock goes into the time-set mode.

Radio Control Inoperative,

refer to Radio Replacement

Insert a known good cassette tape into the tape player.

The cassette tape plays and sound is heard from the speakers.

Tape Player Control Inoperative, refer to Radio Replacement

Tape Player Control Inoperative, refer to Radio Replacement

Press the FWD button.

The cassette tape will fast forward and then reverse.

Tape Player Control Inoperative, refer to Radio Replacement

Press the REV button.

The cassette tape will reverse.

Tape Player Control Inoperative, refer to Radio Replacement

Press the AM/FM button.

Sound toggles from the cassette tape player to the radio tuner.

Tape Player Control Inoperative, refer to Radio Replacement

Press the EJECT button.

The cassette tape player will eject tape.

Tape Player Control Inoperative, refer to Radio Replacement

Insert a known good compact disc (CD) (w/signal disc CD player).

The CD plays and sound is heard from the speakers.

Press the TUNE-SEEK button.

The CD moves to the next selection and plays.

CD Player Control Inoperative, refer to Radio Replacement

CD Player Control Inoperative, refer to Radio Replacement

CD Player Control Inoperative, refer to Radio Replacement

1. Ensure that the compact disc (CD) player is loaded and installed (w/12 disc CD player).
2. Press the SOURCE button.

The CD player plays and sound is heard from the speakers.

* Refer to the appropriate symptom diagnostic table for the applicable abnormal result.