Tools Required

J 39232 Wiper Transmission Separator

1. Remove the wiper arms. Refer to Windshield Wiper Arm Replacement .
2. Remove the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement .

Important: The hole in the right-hand side of the plenum must be used for transmission removal. Rotate the transmission as necessary to extract it from the plenum.

3. Remove the transmission drive link socket from the wiper motor crank arm using the J 39232 Wiper Transmission Separator.



4. Remove the six screws and the transmission from the vehicle.

Tools Required

J 39529 Wiper Transmission Installer

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

1. Install the transmission onto the vehicle with six screws.

Tighten
Tighten the screws to 8 N·m (70 lb in).





Important: The socket must be fully seated on the ball.

2. Install the transmission drive link socket to the wiper motor crank arm using the J 39529 Wiper Transmission Installer.
3. Install the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement .
4. Install the wiper arms. Refer to Windshield Wiper Arm Replacement .