Did you perform the Exterior Lights System Check?

--

Go to Step 2

Go to Exterior Lights System Check

1. Turn the ignition switch to the RUN position.
2. Use a J 39200 digital multimeter (DMM) in order to backprobe the turn signal/hazard switch between connector C202 cavity B10 (PNK) and ground.

Is the voltage within the specified range?

10-15 V

Go to Step 3

Go to Step 4

Replace the turn signal/hazard switch.

Is the turn signal/hazard switch replacement complete?

--

Go to Exterior Lights System Check

--

Repair the open in CKT 539 (PNK) between the underhood junction block and the turn signal/hazard switch. Refer to Wiring Repairs in Wiring Systems.

Is the repair complete?

--

Go to Exterior Lights System Check

--