Tools Required

1. Recover the refrigerant from the A/C system. Refer to Refrigerant Recovery and Recharging .

Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.

2. Disconnect the negative battery cable.
3. Disconnect the evaporator tube from the retainer.



4. Remove the evaporator tube retainer.



5. Remove the A/C compressor hose from the accumulator.
6. Remove the accumulator tube from the accumulator.



7. Remove the accumulator bracket retaining bolt.



8. Remove the accumulator from the vehicle.

Tools Required

J 39400 Electronic Halogen Leak Detector

1. Install the accumulator into the bracket.




Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the accumulator bracket retaining bolt.

Tighten
Tighten the bolt to 6 N·m (53 lb in).

3. Install the accumulator tube to accumulator.



4. Install the A/C compressor hose to the accumulator.

Tighten
Tighten the accumulator connections to 24 N·m (18 lb ft).




5. Install the evaporator tube retainer.



6. Install the evaporator tube to the retainer.
7. Connect the negative battery cable.
8. Recharge the A/C system. Refer to Refrigerant Recovery and Recharging .
9. Test the A/C system for leaks using the J 39400 . Refer to Leak Testing .