Removal Procedure
- Remove the four oil filter adapter bolts from the front cover.
- Remove the following components:
| 2.1. | Remove the oil filter adapter. |
| 2.3. | Remove the oil pressure valve. |
| 2.4. | Remove the oil pressure relief valve spring. |
- Clean all parts in a suitable solvent and allow to dry.
- Inspect the following components:
| • | Oil pressure valve (for burrs) |
| • | Valve spring (for loss of tension) |
Installation Procedure
- Install the spring into the front cover.
- Install the oil pressure valve into the front cover.
- Install a new oil filter adapter gasket.
- Install the oil filter adapter.
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the oil
filter adapter bolts.
Tighten
Tighten the bolts to 30 N·m (22 lb ft).
