GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Buick 🢒 1999 🢒 LeSabre 🢒 Body and Accessories 🢒 Lighting Systems 🢒 Daytime Running Lamps (DRL) Resistor Replacement

Removal Procedure
  1. Remove the air cleaner assembly.
  2. Remove the PCM cover.

    3. Object Number: 299418 Size: SH
  3. Remove the resistor screw (2-Buick,4-Pontiac/Oldsmobile) from the front fender.
  4. Disconnect the connector.
  5. Remove the daytime running lamp resistor (1-Pontiac/Oldsmobile,3-Buick).

Installation Procedure

    Object Number: 299418 Size: SH
  1. Connect the connector to the daytime running lamp resistor (1-Pontiac/Oldsmobile,3-Buick).
  2. Connect the daytime running lamp resistor (1-Pontiac/Oldsmobile,3-Buick) to the front fender.

    3. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Install the resistor screw (2-Buick,4-Pontiac/Oldsmobile) to the front fender.

    4. Tighten
    Tighten the screw (2-Buick,4-Pontiac/Oldsmobile) to 7 N·m (62 lb in).

  4. Install the PCM cover.
  5. Install the air cleaner assembly.