Removal Procedure
Caution: Refer to Paint Damage Caution in the Preface section.
- Apply masking tape to the outer applique and frame.
- Remove the front door trim panel. Refer to
Front Side Door Trim Panel Replacement.
- Remove the front door water deflector. Refer to
Front Side Door Water Deflector Replacement.
- Remove the front door inner window belt sealing strip. Refer to
Front Side Door Window Belt Inner Sealing Strip Replacement.
- Lower the window far enough in order to gain access through the inner panel, unsnap the window guide retainer from the window.
- Push inward on the window guide retainer clip locks, lift upward on the window until released from the retaining clip.
- Lower the window regulator to the full down position.
- Remove the window from the door.
Installation Procedure
- Position the window in between the inner and the outer panels.
| 1.1. | Point the lower front corner of the front door window down. |
| 1.2. | Pass the front door window through the belt opening. |
| 1.3. | Align the edges of the window with the door window weatherstrip. |
| 1.4. | Ensure that both sealing lips on the front door outer belt sealing strip are not rolled over and pointing downward. |
If this condition is present, the window will not raise properly.
- Raise the window regulator to the middle position.
- Install the rearward window to the guide retainer, snap the window into the window regulator.
- Remove the masking tape.
- Inspect the window for proper operation.
- Install the front door inner belt sealing strip. Refer to
Front Side Door Window Belt Inner Sealing Strip Replacement.
- Install the front door water deflector. Refer to
Front Side Door Water Deflector Replacement.
- Install the front door trim panel. Refer to
Front Side Door Trim Panel Replacement.
