Special Tools

J 45059 Angle Meter

For equivalent regional tools, refer to Special Tools.

1. Install the engine front cover gasket.



2. Install the engine front cover.

Align the cogs on the crankshaft sprocket with the cogs on the oil pump in the engine front cover.

3. Apply sealant GM P/N 12346004 (Canadian P/N 10953480) or the equivalent to the engine front cover bolt threads.

Caution: Refer to Fastener Caution in the Preface section.

4. Install the engine front cover bolts and tighten the engine front cover bolts to 20 N·m (15 lb ft). Use the J 45059 meter to tighten the engine front cover bolts an additional 40 degrees.
5. Install the oil filter and tighten to 30 N·m (22 lb ft).



6. Install the crankshaft position sensor and tighten the crankshaft position sensor studs to 30 N·m (22 lb ft).



7. Install the crankshaft position sensor shield.