DTC B1354. Buick Century 2001

For 1990-2009 cars only

Makes 🢒 Buick 🢒 2001 🢒 Century 🢒 DTC 🢒 DTC B1354

The BCM's ground 2 circuit provides ground for the high current devices controlled by the BCM.

The BCM monitors the ground 2 at all times.

The BCM detects that the ground 2 circuit is not at ground potential for 300 milliseconds.

The BCM stores DTC B1354 in memory.

•	A current DTC B1354 will clear if the BCM no longer detects the fault.

•	A history DTC B1354 will clear after 100 consecutive ignition cycles if the condition for the malfunction is no longer present.

Step	Action	Yes	No
Schematic Reference: Body Control System Schematics
1	Perform the diagnostic system check for the system that exhibits symptoms. Refer to Control Module References . Did you perform the Diagnostic System Check?	Go to Step 2	Go to Control Module References
2	Install a scan tool. Turn ON the ignition, with the engine OFF. With a scan tool, observe the Ground 2 parameter in the Body Control Module input data list. Does the scan tool display Present?	Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems	Go to Step 3
3	Test the ground 2 circuit for an open or high resistance. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition?	Go to Step 6	Go to Step 4
4	Inspect for poor connections at the harness connector of the Body Control Module. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition?	Go to Step 6	Go to Step 5
5	Important: Set up new body control module. Refer to Body Control Module (BCM) Programming/RPO Configuration . Replace the Body Control Module. Refer to Body Control Module Replacement . Did you complete the repair?	Go to Step 6	--
6	Use the scan tool in order to clear the DTCs. Operate the vehicle within the Conditions for Running the DTC as specified in the supporting text. Does the DTC reset?	Go to Step 2	System OK